LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 60 (Interior Trim And Ornamentation -- F250-F550 Super Duty) >> Removal And Installation >> Door Trim Panel - Rear, SuperCab

Door Trim Panel - Rear, SuperCab

WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Door Trim Panel Components - Rear, SuperCab
G06779598Courtesy of FORD MOTOR CO.
Item Part Number Description
1 25508 RH/ 25509 LH Rear door upper trim panel
2 60220-A RH/ 60220-B LH Shoulder safety belt finish trim panel
3 N807673 Scrivet
4 W505920 Rear door lower trim panel screws (3 required)
5 27406 RH/ 27407 LH Rear door lower trim panel

Upper door trim panel 

NOTE: LH side shown in illustration, RH side similar.
  1. Remove the 2 rear window latch screws and position aside the rear window latch.
    Fig 2: Locating Rear Window Latch Screws
    G06779599Courtesy of FORD MOTOR CO.
  2. NOTE: Inspect the shoulder safety belt guide and cover for damage. If the shoulder safety belt guide or cover is damaged or the cover does not remain closed, install a new shoulder safety belt guide.
  3. Remove the shoulder safety belt guide.
    1. Position the shoulder safety belt guide cover upward.
    2. Remove the shoulder safety belt guide bolt.
      • To install, tighten to 40 Nm (30 lb-ft).
    3. Remove the shoulder safety belt guide.
      Fig 3: Identifying Shoulder Safety Belt Guide
      G06779600Courtesy of FORD MOTOR CO.
  4. Remove the rear door upper trim panel.
    • Pull outward to release the rear door upper trim panel clips.

    Lower door trim panel 

  5. Lift up and remove the shoulder safety belt finish trim panel.
    • Route the shoulder safety belt through the shoulder safety belt finish trim panel opening.
      Fig 4: Removing Shoulder Safety Belt Finish Trim Panel
      G06779601Courtesy of FORD MOTOR CO.
  6. Remove the safety belt anchor.
    • Position the safety belt anchor cover downward.
    • Remove the safety belt anchor bolt.
      • To install, tighten to 40 Nm (30 lb-ft).
    • Remove the safety belt anchor.
  7. Remove the scrivet and the 3 rear door lower trim panel screws.
    Fig 5: Locating Rear Door Lower Trim Panel Screws
    G06779602Courtesy of FORD MOTOR CO.
  8. NOTE: Do not pull directly outward on the rear door lower trim panel as damage will occur.
  9. Pull straight up to remove the rear door lower trim panel.
    • Route the shoulder safety belt through the lower rear door trim panel opening.

    Upper and lower door trim panels 

  10. NOTE: Insert the rear door lower trim panel tabs first or they can break when installing the rear door lower trim panel.
    NOTE: To avoid damage to the upper door trim panel, remove any retaining clips from the door and attach them to the upper door trim panel before installing.
  11. To install, reverse the removal procedure.