LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 598 (Anti-Theft System - Passive Anti-Theft System (Pats)) >> Removal And Installation >> Passive Anti-Theft System (PATS) Transceiver >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2014 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the 3 screws and the lower steering column shroud.
  2. Disconnect the Passive Anti-Theft System (PATS) transceiver electrical connector.
  3. Using a suitable tool (such as a dentist pick), pry the PATS  transceiver tangs outward and remove the PATS  transceiver.
  4. NOTE: Replacement of the PATS  transceiver does not require the PATS  keys to be programmed into the Instrument Cluster (IC) again.

    To install, reverse the removal procedure.

scientia non olet · About LEMON Manuals