LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 594 (Information System And Entertainment System - SONY 8-Inch Touchscreen) >> Removal And Installation >> Antenna - AM/FM >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2014 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lower the glove compartment completely.
  2. Disconnect the AM/FM antenna from the AM/FM antenna cable.
    • Push the antenna cable end and the grommet through the side cowl.
      Fig 1: Disconnecting AM/FM Antenna From AM/FM Antenna Cable
      G06172554Courtesy of FORD MOTOR CO.
  3. NOTE: Do not over tighten the antenna mast or damage to the antenna base or mast may occur.

    Remove the AM/FM antenna mast.

    1. To install, tighten to 4.2 Nm (36 lb/in).
  4. NOTE: A new AM/FM antenna base cap must be installed.

    Using a suitable tool such as a hook-shaped pick, remove the AM/FM antenna base cap by prying upward.

  5. Remove the RH  front fender splash shield. For additional information, refer to FRONT END BODY PANELS .
  6. Remove the 3 screws and the AM/FM antenna base.
    1. To install, tighten to 2.5 Nm (23 lb/in).
  7. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals