LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 593 (Information System And Entertainment System - 8 Inch Touchscreen) >> Removal And Installation >> Antenna Cable - Satellite Radio >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2014 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

Both cables 

  1. Lower the glove compartment completely.
  2. Disconnect the upper-to-lower satellite radio antenna cable connection.

    Upper cable 

  3. Remove the RH  A-pillar trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
  4. Remove the 3 screws, the RH  sun visor retaining clip, and the RH  sun visor.
    • If equipped, disconnect the electrical connector.
  5. Lower the front of the headliner enough to gain access to the satellite radio antenna electrical connector.
  6. Remove the upper satellite radio antenna cable.
    • Disconnect the electrical connector.
    • Separate the pushpins from the A-pillar and instrument panel.

      Lower cable 

  7. Remove the Audio Front Control Module (ACM). For additional information, refer to AUDIO CONTROL MODULE (ACM) .
  8. Remove the lower satellite radio antenna cable.
    • Disconnect the electrical connector.
    • Separate the pushpins from the instrument panel.

      Both cables 

  9. To install, reverse the removal procedure.