Power Steering Pump Pulley: Removal
WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The power steering pump and pulley are serviced as an assembly on vehicles equipped with a 6.7L diesel engine.
- Remove the engine cooling fan shroud. For additional information, refer to ENGINE COOLING - GASOLINE ENGINES .
- Rotate the accessory drive belt tensioner and remove the accessory drive belt from the power steering pump pulley.
- Using the Power Steering Pump Pulley Remover, remove the pulley.
- Inspect the pulley for paint marks in the web area near the hub. If there are 2 paint marks, discard the pulley. If there is no paint or one paint mark, use a paint pencil to mark the web area of the pulley near the hub.
- Using the Power Steering Pump Pulley Installer, install the power steering pump pulley.
NOTE:
Installation of a new power steering pump pulley is necessary after being removed and installed 2 times, or pulley and/or pump failure may occur.