Transmission Fluid Cooler Tubes - 3.5L GTDI, 3.7L: Installation

WARNING: This page is about a different car, the 2014 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

Route the transmission fluid cooler tubes and position them in place.
NOTE: Inspect the transmission case to make sure that the transmission fluid cooler tube O-rings did not remain in the transmission case. Carefully remove and discard them from the case if retained.

Install 4 new O-rings on the transmission fluid cooler tubes.
NOTE: Install a new transmission fluid cooler tubes-to-transmission bolt.

Install the transmission fluid cooler tubes and a new transmission fluid cooler tubes-to-transmission bolt.
- Tighten to 30 Nm (22 lb-ft).
If equipped, install the selector lever cable splash shield and the splash shield nut.
- Tighten to 12 Nm (106 lb-in).
Install the transmission fluid cooler tube bracket nut to the starter motor stud bolt.
- Tighten to 12 Nm (106 lb-in).
Install the transmission fluid cooler tube bracket nut to the front of the engine.
- Tighten to 12 Nm (106 lb-in).
Connect the transmission fluid cooler tubes to the transmission fluid cooler hoses.
Install the transmission fluid cooler tube secondary latches.
If equipped, install the skid plate and the 4 bolts.
- Tighten to 48 Nm (35 lb-ft).
If equipped, install the air deflector and the 12 pushpins.
If equipped, install the splash shield and the 4 fasteners.
Fill the transmission with fluid and verify correct operation. For additional information, refer to Transmission Fluid Level Check in AUTOMATIC TRANSAXLE/TRANSMISSION - 6R80 .
Check for leaks.