LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 58 (Anti-Lock Brake System And Stability Control -- F250-F550 Super Duty) >> Removal And Installation >> Wheel Speed Sensor Ring - Rear, Four-Channel >> Installation

Wheel Speed Sensor Ring - Rear, Four-Channel: Installation

WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the wheel speed sensor ring on the rear wheel hub.
  2. Place a block of wood on top of the wheel speed sensor ring and install the ring by gently and evenly tapping the wood block with a hammer.
    Fig 1: Locating Wheel Speed Sensor Ring On Rear Wheel Hub
    G07479200Courtesy of FORD MOTOR CO.
  3. Install the rear wheel hub. For additional information, refer to WHEEL HUBS AND BEARINGS - FULL FLOATING AXLE - FORD .
scientia non olet · About LEMON Manuals