LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 58 (Anti-Lock Brake System And Stability Control -- F250-F550 Super Duty) >> Removal And Installation >> Wheel Speed Sensor - Rear, Four-Channel >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Disconnect the wheel speed sensor electrical connector.
  3. Detach the wheel speed sensor harness from the rear axle.
  4. Remove the wheel speed sensor bolt and the wheel speed sensor.
    • To install, tighten to 20 Nm (177 lb-in).
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals