LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 58 (Anti-Lock Brake System And Stability Control -- F250-F550 Super Duty) >> Removal And Installation >> Wheel Speed Sensor - Front, Four Wheel Drive (4WD) >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the disc brake shield. For additional information, refer to FRONT DISC BRAKE .
  2. Disconnect the wheel speed sensor electrical connector.
  3. Detach the wheel speed sensor harness from the radius arm.
  4. Remove the 3 wheel speed sensor harness bolts.
    • To install, tighten to 12 Nm (106 lb-in).
  5. Remove the wheel speed sensor bolt and the sensor.
    • To install, tighten to 18 Nm (159 lb-in).
    6. NOTE: Make sure the wheel speed sensor harness is correctly routed to prevent the brake disc from damaging the harness.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals