LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 58 (Anti-Lock Brake System And Stability Control -- F250-F550 Super Duty) >> Diagnosis And Testing >> Anti-Lock Control - Three-Channel >> Pinpoint Tests >> Pinpoint Test AH: DTC U3002:62 >> Pinpoint Test Ah: DTC U3002:62

Pinpoint Test Ah: DTC U3002:62

WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. AH1 VERIFY BCMVIN 
    • Ignition ON.
    • Enter the following diagnostic mode on the scan tool: Log Viewer.
    • Compare the VIN in Log Viewer to the vehicle VIN plate.
    • Does VIN in Log Viewer match the vehicle VIN plate? 
      1. Yes  : GO to AH2.
      2. No  : CARRY OUT Programmable Module Installation (PMI) for the BCM. REFER to MODULE CONFIGURATION . TEST the system for normal operation.
  2. AH2 VERIFY ABS MODULE PART NUMBER 
    • Retrieve and record the ABS module part number from Log Viewer and verify that the vehicle has the correct ABS module installed.
    • Is the correct ABS module installed in the vehicle? 
      1. Yes  : CARRY OUT PMI for the ABS module. REFER to MODULE CONFIGURATION . TEST the system for normal operation.
      2. No  : INSTALL a new ABS module. REFER to Anti-Lock Brake System (ABS) Module . CLEAR the DTC. CYCLE the ignition key. REPEAT the self-test.
scientia non olet · About LEMON Manuals