LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 579 (Electronic Engine Controls) >> Removal And Installation >> Crankshaft Position (CKP) Sensor - 5.0L (4V) >> Installation

Crankshaft Position (CKP) Sensor - 5.0L (4V): Installation

WARNING: This page is about a different car, the 2014 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
  1. NOTE: The Crankshaft Position (CKP) sensor bolt is part of the CKP  sensor and cannot be removed.

    Position the CKP  sensor and tighten the bolt.

    • Tighten to 10 Nm (89 lb-in).
  2. Connect the CKP  sensor electrical connector.
  3. Connect the CHT  sensor electrical connector.
  4. Install the intake manifold. For additional information, refer to ENGINE - 5.0L (4V) .
scientia non olet · About LEMON Manuals