LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 577 (Engine Ignition System - 6.2L (2V)) >> Removal And Installation >> Ignition Coil-On-Plug >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2014 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the Air Cleaner (ACL) outlet pipe. For additional information, refer to INTAKE AIR DISTRIBUTION AND FILTERING .
  2. Remove the intake air resonator. For additional information, refer to INTAKE AIR DISTRIBUTION AND FILTERING .
  3. Disconnect the 8 ignition wires.
  4. Disconnect the 8 ignition coil-on-plug electrical connectors.
  5. Remove the 8 ignition coil-on-plug bolts.
    • To install, tighten to 10 Nm (89 lb-in).
  6. NOTE: When removing the ignition coil-on-plugs, a slight twisting motion will break the seal and ease removal.

    Remove the 8 ignition coil-on-plugs.

  7. NOTE: Verify that the coil-on-plug spring is correctly located inside the ignition coil-on-plug boot and that there is no damage to the tip of the boot.

    To install, reverse the removal procedure.

    • Apply a light coat of dielectric compound to the inside of the coil-on-plug boots.
scientia non olet · About LEMON Manuals