LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 572 (Engine Controls - Fuel Charging And Controls - 6.2L (2V)) >> Removal And Installation >> Throttle Body >> Installation

Throttle Body: Installation

WARNING: This page is about a different car, the 2014 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
  1. Using a new O-ring seal, position the TB  and tighten the 4 bolts in 2 stages.
    • Stage 1: Tighten to 12 Nm (106 lb-in).
    • Stage 2: Tighten an additional 60 degrees.
  2. Connect the ETC  electrical connector.
  3. Position the TB  adapter onto the TB  and install the 2 bolts.
    • Tighten to 10 Nm (89 lb-in).
  4. Tighten the TB  adapter-to-TB clamp.
    • Tighten to 5 Nm (44 lb-in).
  5. Connect the crankcase ventilation tube quick connect coupling to the ACL  outlet pipe-to-TB  adapter. For additional information, refer to FUEL SYSTEM - GENERAL INFORMATION .
  6. Connect the brake booster vacuum hose to the ACL  outlet pipe-to-TB  adapter.
  7. Connect the crankcase ventilation tube quick connect fitting to the ACL  outlet pipe-to-TB  adapter. For additional information, refer to FUEL SYSTEM - GENERAL INFORMATION .
  8. Connect the heater coolant hose retainer to the ACL  outlet pipe-to-TB  adapter.
  9. Install the ACL  outlet tube. For additional information, refer to INTAKE AIR DISTRIBUTION AND FILTERING .
scientia non olet · About LEMON Manuals