LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 569 (Engine Controls - Fuel Charging And Controls - 3.5L GTDI) >> Removal And Installation >> Throttle Body >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2014 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the Air Cleaner (ACL) outlet pipe. For additional information, refer to INTAKE AIR DISTRIBUTION AND FILTERING .
  2. Disconnect the Throttle Body (TB) electrical connector.
  3. Loosen the clamp and disconnect the Charge Air Cooler (CAC) outlet pipe-to-TB  .
    • To install, tighten to 5 Nm (44 lb-in).
  4. Remove the 4 bolts and the TB  .
    • Discard the TB  gasket.
    • To install, tighten to 10 Nm (89 lb-in).
  5. NOTE: Install a new TB  gasket.

    To install, reverse the removal procedure.

scientia non olet · About LEMON Manuals