LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 568 (Engine Cooling System) >> Removal And Installation >> Coolant Pump - 3.5L GTDI, 3.7L >> Removal

Coolant Pump - 3.5L GTDI, 3.7L: Removal

WARNING: This page is about a different car, the 2014 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the air cleaner outlet pipe. For additional information, refer to INTAKE AIR DISTRIBUTION AND FILTERING .
  2. Loosen the 4 coolant pump pulley bolts.
  3. Remove the accessory drive belt. For additional information, refer to ACCESSORY DRIVE .
  4. NOTE: Cover the A/C compressor belt to prevent coolant contamination of the belt.

    Completely cover the A/C compressor belt with waterproof plastic.

  5. Remove the thermostat housing. For additional information, refer to THERMOSTAT HOUSING - 3.5L GTDI  or THERMOSTAT HOUSING - 3.7L .
  6. Remove the 4 bolts and the coolant pump pulley.
  7. Remove the 7 bolts and the coolant pump.
    • Remove and discard the gasket and the O-ring seal in the coolant pump.
scientia non olet · About LEMON Manuals