Coolant Crossover Manifold Assembly - 3.5L GTDI: Removal
WARNING: This page is about a different car, the 2014 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
- Drain the cooling system. For additional information, refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING .
- Release the clamp and disconnect the heater hose from the coolant crossover manifold assembly.
- Remove the LH rear intake manifold bolt.
- Remove the 3 bolts and the coolant crossover manifold assembly.
- Remove and discard the gaskets.