Wheel Speed Sensor Ring - Rear: Installation

WARNING: This page is about a different car, the 2014 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Do not apply any amount of force to the tooth area of the wheel speed sensor ring during installation, the sensor teeth are fragile and can be easily damaged. Apply force only to the inner lip area of the wheel speed sensor ring.

Using suitable adapters, press the wheel speed sensor ring onto the rear axle shaft.

Fig 1: Removing Wheel Speed Sensor Ring From Axle Shaft
Courtesy of FORD MOTOR CO.
Install the rear axle shaft. For additional information, refer to REAR DRIVE AXLE/DIFFERENTIAL - FORD 8.8-INCH RING GEAR or REAR DRIVE AXLE/DIFFERENTIAL - FORD 9.75-INCH RING GEAR .