LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 565 (Anti-Lock Brake System (Abs) And Stability Control) >> Removal And Installation >> Wheel Speed Sensor - Front >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2014 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the brake disc. For additional information, refer to FRONT DISC BRAKE .
  2. NOTE: The wheel speed sensor harness electrical connector is located in the engine compartment secured to the fender apron.

    Disconnect the wheel speed sensor electrical connector.

  3. Detach the 2 wheel speed sensor harness pushpin retainers.
  4. Detach the wheel speed sensor harness retainer from the brake hose.
  5. Remove the wheel speed sensor harness bolt.
    • To install, tighten to 12 Nm (106 lb-in).
  6. Remove the wheel speed sensor bolt and the wheel speed sensor.
    • To install, tighten to 17 Nm (150 lb-in).
  7. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals