Removal and Installation

WARNING: This page is about a different car, the 2014 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: For automatic transmissions, when installing a new driveshaft, match the yellow dots on the driveshaft to the yellow dots on the pinion flange and the output shaft to maintain balance during installation.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
Index-mark the driveshaft flange to the pinion flange and the driveshaft flange to the transmission flange to maintain alignment during installation.

Fig 1: Locating Index-Mark On Driveshaft Flange Yoke And Pinion Flange
Courtesy of FORD MOTOR CO.
Remove and discard the 4 driveshaft flange bolts.
- To install, tighten the 4 new bolts to 103 Nm (76 lb-ft).
  
  Fig 2: Locating Flange Bolt
  Courtesy of FORD MOTOR CO.
NOTE: The driveshaft flange fits tightly on the flange pilot. Never hammer on the driveshaft or any of its components to disconnect the driveshaft flange from the flange pilot. Pry only in the area shown below with a suitable tool to disconnect the driveshaft flange from the flange pilot or damage to the driveshaft flange can occur.

Using a suitable tool as shown below, disconnect the driveshaft flange from the flange pilot and remove the driveshaft.

Fig 3: Disconnecting Driveshaft Centering Socket Yoke From Pinion Flange
Courtesy of FORD MOTOR CO.
NOTE: The driveshaft flange fits tightly on the pinion flange pilots. To make sure that the driveshaft flanges seat squarely on the pinion flange pilots, tighten the driveshaft flange bolts evenly in a cross pattern or damage to the flanges can occur.

NOTE: If new bolts are not available, coat the threads of the original driveshaft flange bolts with threadlock and sealer.

NOTE: Align the index marks made during removal.

To install, reverse the removal procedure.