LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 557 (Four Wheel Drive (4WD) Systems) >> Removal And Installation >> Integrated Wheel End (IWE) >> Removal

Integrated Wheel End (IWE): Removal

WARNING: This page is about a different car, the 2014 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the brake disc. Refer to FRONT DISC BRAKE .
  2. Remove the dust cap.
    G09377911
  3. Remove and discard the axle nut.
    G09377912
  4. Disconnect the vacuum tubes from the Integrated Wheel End (IWE).
  5. Remove the 3 IWE  -to-wheel knuckle retaining bolts.
  6. Remove the tie-rod nut and separate the tie rod from the wheel knuckle.
    • Discard the tie-rod nut.
  7. Remove the wheel speed sensor harness bracket bolt. Detach the wheel speed sensor retainers.
    G09378867
  8. Disconnect the wheel speed sensor harness and position the harness aside.
    G09378868
  9. Remove the front brake flexible hose bracket bolt and position the brake hose aside.
  10. Remove the upper ball joint nut and separate the upper ball joint from the wheel knuckle.
    • Discard the upper ball joint nut.
  11. NOTE: Allow the wheel knuckle to swing outward while keeping the halfshaft pushed inward.

    Once clearance is available, remove the halfshaft outboard end from the wheel knuckle hub bearing.

  12. Remove the IWE  from the halfshaft outboard end.
scientia non olet · About LEMON Manuals