LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 555 (Wheel Hubs And Bearings - 9.75 Inch Ring Gear) >> In-Vehicle Repair >> Electronic Locking Differential (ELD) Field Coil >> Removal

Electronic Locking Differential (ELD) Field Coil: Removal

WARNING: This page is about a different car, the 2014 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the differential carrier. For additional in formation, refer to DIFFERENTIAL CARRIER .
  2. Using the Bearing Puller plate, Step Plate and a suitable press, remove the LH differential bearing.
    Fig 1: Removing LH Differential Bearing
    G06166988Courtesy of FORD MOTOR CO.
  3. Remove and discard the 6 screws and 3 stoppers that hold the Electronic Locking Differential (ELD) coil in place and remove the coil.
    Fig 2: Locating Screws And Stoppers
    G06167052Courtesy of FORD MOTOR CO.
  4. Remove and discard the plunger assembly.
    Fig 3: Locating Plunger Assembly
    G06167053Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals