LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 555 (Wheel Hubs And Bearings - 9.75 Inch Ring Gear) >> In-Vehicle Repair >> Electronic Locking Differential (ELD) Field Coil >> Installation

Electronic Locking Differential (ELD) Field Coil: Installation

WARNING: This page is about a different car, the 2014 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install a new plunger assembly.
    Fig 1: Locating Plunger Assembly
    G06167053Courtesy of FORD MOTOR CO.
  2. Install the new ELD  coil, 3 stoppers and 6 screws that hold the coil in place.
    • Tighten to 5 Nm (44 lb-in).
      Fig 2: Locating Screws And Stoppers
      G06167052Courtesy of FORD MOTOR CO.
  3. Use the Differential Carrier Bearing Installer to install the LH differential bearing.
    Fig 3: Installing Differential Bearings
    G06125158Courtesy of FORD MOTOR CO.
  4. Install the differential carrier. For additional information, refer to DIFFERENTIAL CARRIER .
scientia non olet · About LEMON Manuals