LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 554 (Rear Drive Axle/Differential - 8.8 Inch Ring Gear) >> In-Vehicle Repair >> Rear Wheel Bearing and Axle Shaft Seal >> Removal

Rear Wheel Bearing and Axle Shaft Seal: Removal

WARNING: This page is about a different car, the 2014 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the axle shaft. For additional information, refer to AXLE SHAFT .
  2. NOTE: If the axle shaft oil seal is leaking, the axle housing vent may be plugged with foreign material.
    NOTE: Use care to avoid damaging the axle shaft oil seal bore.

    Using a suitable seal remover, remove and discard the axle shaft oil seal.

  3. Inspect the rear wheel bearing and axle shaft for wear or damage.
  4. If necessary, using the Axle Bearing Remover and Slide Hammer, remove the rear wheel bearing.
    Fig 1: Removing Rear Wheel Bearing
    G06166740Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals