LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 554 (Rear Drive Axle/Differential - 8.8 Inch Ring Gear) >> In-Vehicle Repair >> Axle Shaft >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2014 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove the rear wheel and tire. For additional information, refer to WHEELS AND TIRES .
  3. Remove the rear brake disc. For additional information, refer to REAR DISC BRAKE .
    • To install, tighten to 15 Nm (133 lb-in).
      G07957228
  5. Remove the differential housing cover and drain the lubricant. For additional information, refer to DIFFERENTIAL HOUSING COVER .
  6. Discard the specified component. Follow local disposal regulations.
    • To install, tighten to 30 Nm (22 lb-ft).
      G07957229
  7. G07957230
  8. G07957231
  9. To install, reverse the removal procedure.
    • Inspect and lubricate the lip of the wheel bearing oil seal with grease.
scientia non olet · About LEMON Manuals