LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 553 (Steering Column Switches) >> Removal And Installation >> Steering Column Control Module (SCCM) >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2014 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the steering wheel rotation sensor. For additional information, refer to STEERING WHEEL ROTATION SENSOR .
  2. Disconnect the 3 Steering Column Control Module (SCCM) electrical connectors.
  3. Remove the 3 screws and the SCCM  .
    • To install, tighten to 2 Nm (18 lb-in).
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals