Removal and Installation

WARNING: This page is about a different car, the 2014 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

Manual and Power Columns

Remove the steering column shrouds. For additional information, refer to STEERING COLUMN .
Disconnect the ignition switch electrical connector.
Manual Columns
Place the steering column tilt lever in the unlocked position.
Manual and Power Columns
Press the 2 locking tabs and remove the ignition switch.

Fig 1: Locating Ignition Switch Electrical Connector
Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.