Instrument Panel Cluster (IPC): Removal

WARNING: This page is about a different car, the 2014 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: If installing a new Instrument Panel Cluster (IPC), all vehicle keys are erased during the parameter reset procedure. Verify at least 2 of the vehicle keys are available prior to carrying out this procedure.

If installing a new IPC , upload the IPC configuration information to the scan tool. For additional information, refer to MODULE CONFIGURATION .
Tilt and telescope the steering column to the full downward and rearward position.
If equipped with a column shift, apply the parking brake and lower the gear shift to the lowest gear.
Remove the 2 screws and the IPC center finish panel.
- Release the gap hider retainers.
Remove the 4 screws and the IPC .
- Disconnect the electrical connector.