LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 549 (Information Center - Instrumentation, Message Center, And Warning Chimes) >> Removal And Installation >> Instrument Panel Cluster (IPC) >> Installation

Instrument Panel Cluster (IPC): Installation

WARNING: This page is about a different car, the 2014 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the IPC  , connect the electrical connector and install the 4 screws.
    G07964108
  2. Install the IPC  finish panel and the 2 screws.
    • Attach the gap hider retainers.
      G07964109
  3. If installing a new IPC  , download the IPC  configuration information from the scan tool into the new IPC  . For additional information, refer to Programmable Module Installation (PMI) in MODULE CONFIGURATION .
  4. NOTE: If a new IPC  is installed, the IPC  and the PCM require a parameter reset to allow the IPC  and the PCM to recognize each other. Failure to carry out the parameter reset to the IC  and the PCM may result in a no start condition.
    NOTE: If equipped, the vehicles Passive Anti-Theft System (PATS) keys must be programmed to the new IPC  .

    If installing a new IPC  , carry out the parameter reset and key programming procedure. For additional information, refer to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) .

scientia non olet · About LEMON Manuals