LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 549 (Information Center - Instrumentation, Message Center, And Warning Chimes) >> Diagnosis And Testing >> Instrumentation, Message Center and Warning Chimes >> Principles of Operation >> Warning Chimes >> IPC Chime Characteristics

IPC Chime Characteristics

WARNING: This page is about a different car, the 2014 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
Chime Name Chime Type Condition Description
Air bag Repetitive Five sequences of 1 second on and 1 second off (10 seconds total)
Belt-Minder® A and B Repetitive The chime sounds 6 chime tones/safety belt warning indicator flash sequences for as long as the IPC  receives the Belt-Minder® chime request.
Door ajar Single tone The chime sounds a single 1.6 second chime tone when any door changes from the closed to the open state.
Headlamps on Repetitive On for as long as the headlamps are on and the IPC  receives the chime on command. Shuts off when battery saver has expired (approximately 30 minutes).
Key-in-ignition Repetitive On for as long as the key is in the ignition with the driver door ajar and the IPC  receives the chime on command. Shuts off when battery saver has expired (approximately 30 minutes).
Memory feedback Single tone The chime sounds for 0.1 second when the IPC  receives a memory state change message.
Message center Single tone The chime is a single 0.1 second tone chime that sounds once per ignition cycle whenever the IPC  receives a new message commanding on one of the message center warnings.
Parking brake on Repetitive On for as long as the parking brake is applied and the IPC  receives the chime on command.
Perimeter alarm Repetitive On for 12 seconds when the driver door is opened using a key and the alarm is armed. The chime sounds 2 chime tones for the first 6 seconds followed by 3 chime tones for the next 4 seconds and finally 4 chime tones for the last 3 seconds.
Safety belt Repetitive Six cycles of 0.5 second on/0.5 second off for as long as the safety belt is unbuckled and the IPC  receives the chime on command.
Service AdvanceTrac® Repetitive The chime sounds three 1.0 second chime tones for as long as the IPC  receives the chime request on command.
Turn signal/hazard on Tick-tock On for as long as the RH or LH turn signal or hazards are on and the IPC  receives the chime on command.
Turn signal left on Repetitive On for as long as the RH or LH turn signal is on and the IPC  receives the chime on command (approximately 3.2 km [2 miles]).
scientia non olet · About LEMON Manuals