Messaged Inputs

WARNING: This page is about a different car, the 2014 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

Module messaging is the standard for sending and receiving information required to operate the IPC . All messages required for the IPC to operate are received over the High Speed Controller Area Network (HS-CAN). For a list of module messages with the message origination sources, refer to MODULE COMMUNICATIONS NETWORK .

Listed below is a partial list of status and information messages that the IPC requires from other vehicle inputs:

ABS
- ABS braking
- Roll Stability Control (RSC®)
- Traction control
Base brake system
- Brake fluid level status
- Parking brake status
Body
- Door ajar
- Supplemental Restraint System (SRS)
- Tire Pressure Monitoring System (TPMS)
Lighting system
- LH/RH turn
- High beam
Powertrain
- Charging system
- ELD
- Engine emission system
- Engine oil pressure
- Engine RPM
- Engine temperature
- Four-Wheel Drive (4WD)
- Tow haul status
- Transmission range
- Vehicle speed