LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 540 (Engine Mechanical - 6.2L (2V)) >> In-Vehicle Repair >> Oil Cooler >> Installation

Oil Cooler: Installation

WARNING: This page is about a different car, the 2014 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the oil cooler and install the threaded shaft.
    • Tighten to 58 Nm (43 lb-ft).
  2. Connect the oil cooler coolant hose quick connect couplings. For additional information, refer to FUEL SYSTEM - GENERAL INFORMATION .
  3. Install a new oil filter in 2 stages.
    • Stage 1: Tighten to 5 Nm (44 lb-in).
    • Stage 2: Tighten an additional 180 degrees.
  4. Fill and bleed the engine cooling system. For additional information, refer to ENGINE COOLING .
scientia non olet · About LEMON Manuals