Crankshaft Front Seal: Removal

WARNING: This page is about a different car, the 2014 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
Rotate the tensioner clockwise and remove the accessory drive belt from the crankshaft pulley.

Fig 1: Removing Accessory Drive Belt From Crankshaft Pulley
Courtesy of FORD MOTOR CO.
Remove and discard the crankshaft pulley bolt.
Using the 3 Jaw Puller and Step Plate, remove the crankshaft pulley.

Fig 2: Removing Crankshaft Pulley
Courtesy of FORD MOTOR CO.
NOTE: Use care not to damage the engine front cover or the crankshaft when removing the seal.

Using the Oil Seal Remover, remove the crankshaft front oil seal.