Removal and Installation

WARNING: This page is about a different car, the 2014 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

Remove the transmission. For additional information, refer to AUTOMATIC TRANSAXLE/TRANSMISSION - 6R80 .

NOTE: The flexplate bolts are torque-to-yield design and are not reusable.

Remove the 8 bolts and the flexplate.

Discard the bolts.

To install, tighten in the sequence shown below in 2 stages.

Stage 1: Tighten to 20 Nm (177 lb-in).

Stage 2: Tighten an additional 60 degrees.

To install, reverse the removal procedure.
- After completing the repairs, use the scan tool to perform the Misfire Monitor Neutral Profile Correction procedure, following the on-screen instructions.