LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 539 (Engine Mechanical - 5.0L (4V)) >> In-Vehicle Repair >> Exhaust Manifold - RH >> Installation

Exhaust Manifold - RH: Installation

WARNING: This page is about a different car, the 2014 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install 4 new lower RH exhaust manifold studs.
    • Tighten to 25 Nm (18 lb-ft).
  2. Install a new gasket, the RH exhaust manifold and 4 new lower exhaust manifold nuts.
    • Do not tighten the nuts at this time.
  3. Install 4 new upper RH exhaust manifold studs.
    • Tighten to 25 Nm (18 lb-ft).
  4. Install 4 new upper RH exhaust manifold nuts.
    • Do not tighten the nuts at this time.
  5. Tighten the nuts in the sequence shown below in 2 stages.
    • Stage 1: Tighten to 24 Nm (18 lb-ft).
    • Stage 2: Tighten to 32 Nm (24 lb-ft).
      G07960633
  6. Position the exhaust Y-pipe dual catalytic converter onto the exhaust manifolds and loosely install 2 new RH catalytic converter-to-exhaust manifold nuts.
    G07960632
  7. Loosely install 2 new LH catalytic converter-to-exhaust manifold nuts.
    G07960631
  8. Tighten the 2 new RH catalytic converter-to-exhaust manifold nuts in the following sequence.
    1. Tighten the RH lower catalytic converter-to-exhaust manifold nut to 40 Nm (30 lb-ft).
    2. Tighten the RH upper catalytic converter-to-exhaust manifold nut to 40 Nm (30 lb-ft).
      G07960636
  9. Tighten the 2 new LH catalytic converter-to-exhaust manifold nuts in the following sequence.
    1. Tighten the LH outer catalytic converter-to-exhaust manifold nut to 40 Nm (30 lb-ft).
    2. Tighten the LH inner catalytic converter-to-exhaust manifold nut to 40 Nm (30 lb-ft).
      G07960637
  10. Position the exhaust Y-pipe dual catalytic converter-to-exhaust intermediate pipe and install the 2 new bolts.
    1. Tighten the inner exhaust Y-pipe dual catalytic converter-to-exhaust intermediate pipe bolt to 63 Nm (46 lb-ft).
    2. Tighten the outer exhaust Y-pipe dual catalytic converter-to-exhaust intermediate pipe bolt to 63 Nm (46 lb-ft).
      G07960638
  11. Install the RH exhaust manifold heat shield and the 3 bolts.
    • Tighten to 12 Nm (106 lb-in).
  12. Connect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  13. Install the A/C  compressor. For additional information, refer to CLIMATE CONTROL .
scientia non olet · About LEMON Manuals