LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 538 (Engine Mechanical - 3.7L) >> In-Vehicle Repair >> Engine Oil Pressure (EOP) Switch >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2014 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the Engine Oil Pressure (EOP) switch electrical connector.
  2. Remove the EOP  switch.
    • To install, tighten to 14 Nm (124 lb-in) then an additional 180 degrees.
  3. To install, reverse the removal procedure.
    • Apply thread sealant with PTFE to the EOP  switch threads prior to installation.
scientia non olet · About LEMON Manuals