LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 538 (Engine Mechanical - 3.7L) >> In-Vehicle Repair >> Cylinder Head - RH >> Installation

Cylinder Head - RH: Installation

WARNING: This page is about a different car, the 2014 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
  1. NOTE: If the cylinder head is replaced, a new secondary timing chain tensioner will need to be installed.

    Install a new gasket, the RH cylinder head and 8 new bolts. Tighten in the sequence shown below in 5 stages:

    • Stage 1: Tighten to 20 Nm (177 lb-in).
    • Stage 2: Tighten to 35 Nm (26 lb-ft).
    • Stage 3: Tighten 90 degrees.
    • Stage 4: Tighten 90 degrees
    • Stage 5: Tighten 45 degrees.
      G07958770
  2. Install the M6 bolt.
    • Tighten to 10 Nm (89 lb-in).
      G07958768
  3. NOTE: The valve tappets must be installed in their original positions.
    NOTE: Coat the valve tappets with clean engine oil prior to installation.

    Install the RH valve tappets.

    G07958767
  4. Install the ground wire and bolt to the rear of the RH cylinder head.
    • Tighten to 10 Nm (89 lb-in).
  5. NOTE: Lubricate the 2 CMP  sensor O-ring seals with clean engine oil.

    Install the 2 RH CMP  sensors and the 2 bolts.

    • Tighten to 10 Nm (89 lb-in).
      G07959741
  6. Connect the 2 RH CMP  sensors electrical connectors.
    G07959740
  7. Install the RH upper primary timing chain guide and the bolt.
    • Tighten to 10 Nm (89 lb-in).
  8. Connect the CHT  sensor electrical connector.
  9. Install the lower intake manifold. For additional information, refer to LOWER INTAKE MANIFOLD .
  10. Install the RH camshafts. For additional information, refer to CAMSHAFT - RH .
  11. Raise the catalytic converter and install the new LH and RH catalytic converter-to-exhaust manifold nuts.
    • Tighten to 45 Nm (35 lb-ft).
  12. Position the exhaust Y-pipe dual catalytic converter-to-exhaust intermediate pipe and install the 2 new bolts.
    • Tighten the inner exhaust Y-pipe dual catalytic converter-to-exhaust intermediate pipe bolt to 63 Nm (46 lb-ft).
    • Tighten the outer exhaust Y-pipe dual catalytic converter-to-exhaust intermediate pipe bolt to 63 Nm (46 lb-ft).
      G07959726
  13. Connect and attach the RH and LH HO2S electrical connectors.
  14. Connect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
scientia non olet · About LEMON Manuals