Crankshaft Rear Seal with Retainer Plate: Removal

WARNING: This page is about a different car, the 2014 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: During engine repair procedures, cleanliness is extremely important. Any foreign material, including any material created while cleaning gasket surfaces that enters the oil passages, coolant passages or the oil pan, can cause engine failure.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
Remove the flexplate. For additional information, refer to FLEXPLATE .
Remove the crankshaft sensor ring.
Remove the engine-to-transmission spacer plate.

Fig 1: Locating Engine-To-Transmission Spacer Plate
Courtesy of FORD MOTOR CO.
Remove the nut, the bolt and the heat shield.

Fig 2: Locating Heat Shield With Bolt And Nut
Courtesy of FORD MOTOR CO.
Remove the wiring harness retainer stud bolt.

Fig 3: Locating Wiring Harness Retainer Stud Bolt
Courtesy of FORD MOTOR CO.
Remove the wiring harness grommet.

Fig 4: Locating Wiring Harness Grommet
Courtesy of FORD MOTOR CO.
Disconnect the Crankshaft Position (CKP) sensor electrical connector.

Fig 5: Locating Crankshaft Position (CKP) Sensor Electrical Connector
Courtesy of FORD MOTOR CO.
Remove the bolt and the CKP sensor.

Fig 6: Locating CKP Sensor And Bolt
Courtesy of FORD MOTOR CO.
If equipped, remove the bolts and the skid plate.

Fig 7: Locating Skid Plate Bolts
Courtesy of FORD MOTOR CO.
Remove the 2 oil pan-to-crankshaft rear seal retainer plate bolts.
Remove the 8 bolts and the crankshaft rear seal retainer plate.
- Discard the crankshaft rear seal retainer plate.
NOTE: Do not use wire brushes, power abrasive discs or 3M™ Roloc® Bristle Disk (2-in white, part number 07528) to clean the sealing surfaces. These tools cause scratches and gouges that make leak paths. They also cause contamination that causes premature engine failure. Remove all traces of the gasket.

Clean the sealing surfaces of the cylinder block and oil pan flange in the following sequence.
1. Remove any large deposits of silicone or gasket material.
2. Apply silicone gasket remover and allow to set for several minutes.
3. Remove the silicone gasket remover. A second application of silicone gasket remover may be required if residual traces of silicone or gasket material remain.
4. Apply metal surface prep to remove any remaining traces of oil and to prepare the surfaces to bond. Do not attempt to make the metal shiny. Some staining of the metal surfaces is normal.