LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 537 (Engine Mechanical - 3.5L GTDI) >> In-Vehicle Repair >> Exhaust Manifold - RH >> Removal

Exhaust Manifold - RH: Removal

WARNING: This page is about a different car, the 2014 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the RH turbocharger. For additional information, refer to FUEL CHARGING AND CONTROLS - TURBOCHARGER .
  2. Remove the 8 exhaust manifold nuts and the RH exhaust manifold.
    • Discard the nuts and gasket.
  3. Clean and inspect the RH exhaust manifold. For additional information, refer to ENGINE SYSTEM - GENERAL INFORMATION .
  4. Remove and discard the 8 RH exhaust manifold studs.
  5. NOTE: Do not use metal scrapers, wire brushes, power abrasive discs or other abrasive means to clean the sealing surfaces. These may cause scratches and gouges resulting in leak paths. Use a plastic scraper to clean the sealing surfaces.

    Clean the exhaust manifold mating surface of the cylinder head with metal surface prep. Follow the directions on the packaging.

scientia non olet · About LEMON Manuals