Exhaust Manifold - RH: Installation

WARNING: This page is about a different car, the 2014 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

Install 8 new RH exhaust manifold studs.
- Tighten to 12 Nm (106 lb-in).
NOTE: Failure to tighten the exhaust manifold nuts to specification a second time will cause the exhaust manifold to develop an exhaust leak.

Using a new gasket, install the RH exhaust manifold and 8 new nuts. Tighten in 2 stages in the sequence shown in illustration:
- Stage 1: Tighten to 19 Nm (168 lb-in).
- Stage 2: Tighten to 25 Nm (18 lb-ft).
Install the RH turbocharger. For additional information, refer to FUEL CHARGING AND CONTROLS - TURBOCHARGER .