Cylinder Head: Disassembly

WARNING: This page is about a different car, the 2014 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

All cylinder heads

Remove the 8 nuts and the exhaust manifold.
- Discard the nuts and gasket.
Clean and inspect the exhaust manifold. For additional information, refer to ENGINE SYSTEM - GENERAL INFORMATION .
Remove and discard the 8 exhaust manifold studs.
Remove the timing chain guide pin.
Remove the turbocharger coolant return fitting.
NOTE: If the components are to be reinstalled, they must be installed in the same positions. Mark the components for installation into their original locations.

Using the Valve Spring Compressors, remove the keys, retainer and spring.

Fig 1: Removing Keys, Retainer And Spring
Courtesy of FORD MOTOR CO.
Remove the valve from the cylinder head.
Remove and discard the valve stem seal.
Repeat the above steps for each valve.
RH cylinder head
Remove the timing chain tensioner arm pin.