LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 535 (Front Suspension (RWD)) >> Removal And Installation >> Ball Joint - Lower >> Installation

Ball Joint - Lower: Installation

WARNING: This page is about a different car, the 2014 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
  1. NOTE: Do not damage the lower ball joint boot when installing the C-Frame and Screw Installer/Remover and Ball Joint Installer/Remover or premature failure of the ball joint may occur.

    Using Special Tool(s): Installer/Remover, C-Frame and Screw 205-086. Remover, Ball Joint 204-358/3. Remover, Ball Joint 204-358/5. Remover, Ball Joint 204-358/6, Install the ball joint.

    G09377907
  2. NOTE: Make sure the ball joint snap ring is fully seated.

    Install the new snap ring.

    G09377908
  3. Install the wheel knuckle. Refer to WHEEL KNUCKLE .
scientia non olet · About LEMON Manuals