LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 534 (Brake System - General Information) >> Diagnosis And Testing >> Symptom Chart >> Symptom Chart - NVH

Symptom Chart - NVH

WARNING: This page is about a different car, the 2014 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
SYMPTOM CHART - NVH

Condition Possible Sources Action
NOTE: NVH symptoms should be identified using the diagnostic tools that are available. For a list of these tools, an explanation of their uses and a glossary of common terms, refer to NOISE, VIBRATION & HARSHNESS . Since it is possible any one of multiple systems may be the cause of a symptom, it may be necessary to use a process of elimination type of diagnostic approach to pinpoint the responsible system. If this is not the causal system for the symptom, refer back to NOISE, VIBRATION & HARSHNESS for the next likely system and continue diagnosis.
  • Vibration when the brakes are applied
  • Brake disc(s)
  • Suspension components
  • Brake vibration/shudder - occurs when the brake pedal is released
  • Brake drag
  • Rear brake noise - occurs when the brake pedal is unapplied
  • Parking brake component
  • Rattling noise
  • Caliper guide pins or guide pin bolts
  • Missing or damaged anti-rattle clips or springs
  • CHECK the brake pads for missing clips or broken springs. INSTALL new components as necessary. REFER to FRONT DISC BRAKE for front disc brakes or REAR DISC BRAKE for rear disc brakes.
  • Loose brake disc shield
  • Squealing noise - occurs on first (morning) brake application
  • Brake pads
  • Acceptable condition. Caused by humidity and low brake pad temperature.
  • Squealing noise - a continuous squeal
  • Brake pads
  • Squealing noise - an intermittent squeal
  • Brake pads
  • Acceptable condition. Caused by cold, heat, water, mud or snow.
  • Groaning noise - occurs at low speeds with brake lightly applied (creeping)
  • Brake pads
  • Acceptable condition.
  • Grinding/moaning noise - continuous
  • Brake pads
  • Brake disc
  • INSPECT the brake pads, brake discs and attaching hardware. VERIFY brake components are within specifications. REFER to BRAKE SYSTEM INSPECTION .