Diagnostic Aids

WARNING: This page is about a different car, the 2014 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

DTC U3000:41, the PSCM disables steering assist and enters into a manual mode. The module sends a message to the IPC to display POWER STEERING ASSIST FAULT in the message center.
DTC U3000:46, initially the PSCM uses a default steering assist and may set DTC U2100:00. If DTC U3000:46 returns on the next ignition cycle, the PSCM disables steering assist, enters into a manual mode and sends a message to the IPC to display POWER STEERING ASSIST FAULT in the message center.
DTC U3000:49, the PSCM disables steering assist and enters a manual mode. The module sends a message to the IPC to display POWER STEERING ASSIST FAULT in the message center.
For DTC U3000:96, the IPC displays SERVICE POWER STEERING NOW in the message center when this DTC is set.

Failure	Action
41	GO to PINPOINT TEST B
46	GO to PINPOINT TEST B
49	GO to PINPOINT TEST B
96	INSTALL a new EPAS steering gear. REFER to POWER STEERING .