DTC C200B: Steering Shaft Torque Sensor 1: Description
WARNING: This page is about a different car, the 2014 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
The PSCM continually monitors the steering shaft torque sensor when the ignition is ON and the voltage supply to the PSCM is above 6.5 volts.
- DTC C200B:2F (Steering Shaft Torque Sensor 1: Signal Erratic) - This DTC sets if the steering shaft torque sensor signal is outside the expected range.
- DTC C200B:61 (Steering Shaft Torque Sensor 1: Signal Calculation Failure) - This DTC sets if the steering shaft torque sensor signal is not within a certain threshold.
- DTC C200B:62 (Steering Shaft Torque Sensor 1: Signal Compare Failure) - This DTC sets if the steering shaft torque sensor signal does not match other sensor inputs.