LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 53 (Driveshaft -- F250-F550 Super Duty) >> Disassembly And Assembly >> Driveshaft Slip Yoke >> Disassembly

Driveshaft Slip Yoke: Disassembly

WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the driveshaft from the vehicle. For additional information, refer to Driveshaft - Exploded View .
    2. NOTE: Do not clamp the driveshaft in the jaws of a vise or a similar holding fixture.
  2. Place the driveshaft on a suitable workbench.
  3. Index-mark the driveshaft slip yoke and the stub shaft.
    Fig 1: Index-Marking Driveshaft Slip Yoke And Stub Shaft
    G06776568Courtesy of FORD MOTOR CO.
  4. Remove the driveshaft slip yoke.
    1. Cut and discard the 2 driveshaft slip yoke boot clamps.
    2. Separate the driveshaft slip yoke from the stub shaft.
    Fig 2: Separating Driveshaft Slip Yoke From Stub Shaft
    G06776569Courtesy of FORD MOTOR CO.
  5. Remove and discard the driveshaft slip yoke boot.
    Fig 3: Removing Driveshaft Slip Yoke Boot
    G06776570Courtesy of FORD MOTOR CO.
  6. Check the lubricant for contamination. If the lubricant feels gritty, clean and inspect the stub shaft and driveshaft slip yoke for wear. Install new components as necessary.
Fig 4: Inspecting Stub Shaft And Driveshaft Slip Yoke
G06776571Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals