Toe Adjustment - Front

WARNING: This page is about a different car, the 2014 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

Using alignment equipment and the manufacturer's instructions, measure the front toe.
- Refer to ALIGNMENT SPECIFICATIONS in the Specifications portion of this article for optimal alignment settings.
- If the front toe values are not within specification, go to the next step.
Start the engine and center the steering wheel.
Turn the engine off and, using a suitable steering wheel holding device, lock the steering wheel in the straight-ahead position.
Remove the steering gear bellows clamp(s).

Fig 1: Locating Steering Gear Bellows Clamps
Courtesy of FORD MOTOR CO.
Loosen the tie-rod end jam nut(s).

Fig 2: Locating Tie-Rod End Jam Nut
Courtesy of FORD MOTOR CO.
NOTE: Do not allow the steering gear bellows to twist while rotating the tie rod.

Rotate the tie rod(s) to achieve the desired toe setting.

Fig 3: Locating Tie Rod
Courtesy of FORD MOTOR CO.
NOTE: Make sure to hold the tie-rod end stationary while tightening the jam nut or damage to the boot may occur.

NOTE: Make sure that the toe settings are not disturbed while tightening the jam nuts.

Tighten the tie-rod end jam nut(s) to 103 Nm (76 lb-ft).

Fig 4: Locating Tie-Rod End Jam Nut
Courtesy of FORD MOTOR CO.
Install the steering gear bellows clamp(s).

Fig 5: Locating Steering Gear Bellows Clamps
Courtesy of FORD MOTOR CO.