Safety Belt Retractor and Pretensioner - Regular Cab and Crew Cab
WARNING: This page is about a different car, the 2014 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
For information on Ford Color Coded Illustrations refer to COLOR-CODING - FORD
.
NOTE:
Crew Cab shown, regular cab similar.
Fig 1: Safety Belt Retractor And Pretensioner Replacement Components With Torque Specifications (Regular Cab And Crew Cab)
| Item | Part Number | Description |
|---|---|---|
| 1 | - | D-ring bolt (part of 612D64) |
| 2 | 60262 | D-ring cover |
| 3 | 612D64 | Safety belt retractor |
| 4 | - | Pretensioner electrical connector (part of 14A005) |
| 5 | - | Safety belt retractor bolt (part of 612D64) |
| 6 | 61692 | Safety belt anchor cover |
| 7 | - | Safety belt anchor bolt (part of 612D64) |
| 8 | - | Belt Tension Sensor (BTS) electrical connector |
WARNING:
All safety belt components must be inspected and corrected as part of any collision repair. Inspect all safety belt components as prescribed by SAFETY BELT INSPECTION AND REPAIR AFTER A COLLISION . Failure to follow this instruction may result in incorrect operation of the safety belt system and increase the risk of serious personal injury or death in a crash.
NOTE:
The air bag warning indicator illuminates when the correct Restraints Control Module (RCM) fuse is removed and the ignition is ON.
NOTE:
The Supplemental Restraint System (SRS) must be fully operational and free of faults before releasing the vehicle to the customer.
- Depower the SRS . For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering in the General Procedures portion of SUPPLEMENTAL RESTRAINT SYSTEM .
- Remove the B-pillar trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
- Remove the bolt, rotate the retractor to detach the hook from the B-pillar sheet metal and remove the safety belt retractor.
- To install, tighten to 40 Nm (30 lb-ft).
- Disconnect the safety belt retractor and pretensioner electrical connector.
- Remove the safety belt retractor.
-
NOTE: Before installation, make sure the safety belt webbing is not twisted and the safety belts and buckles are accessible to the occupants. To install, reverse the removal procedure.
To install, reverse the removal procedure.
- Repower the SRS . For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering in the General Procedures portion of SUPPLEMENTAL RESTRAINT SYSTEM .
- Check the active restraint system for correct operation. For additional information, refer to the appropriate FUNCTIONAL TEST procedure in SAFETY BELT SYSTEM .