P061E - Internal Control Module Brake Signal Performance
WARNING: This page does not describe the selected car, but rather 28 other vehicles, including the 2014 Lincoln Navigator, 2014 Lincoln MKZ, 2014 Lincoln MKX, 2014 Lincoln MKT, and 2014 Lincoln MKS. However, it is still accessible from the selected car via links, so may be relevant.
P061E - INTERNAL CONTROL MODULE BRAKE SIGNAL PERFORMANCE
| Description: This DTC sets when an incorrect brake pedal position (BPP) sensor signal is received by the PCM. This DTC also sets when an internal PCM communication error occurs in the PCM. | |||
Possible Causes:
|
|||
| Diagnostic Aids: Check for an incorrectly adjusted BPP sensor. Refer to Exterior Lighting. Check for other DTCs and diagnose those first. Check for aftermarket performance products before installing a new PCM. Clear the DTCs, repeat the self-test. If the DTC is retrieved again, install a new PCM. Refer to FLASH ELECTRICALLY ERASABLE PROGRAMMABLE READ ONLY MEMORY (EEPROM) , Programming the VID Block for a Replacement PCM. | |||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | Refer to the Description, Possible Causes and Diagnostic Aids for the DTC. | ||