LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 510 (Engine Controls - Powertrain DTC Charts & Descriptions (Except Diesel & Hybrid)) >> DTC Diagnosis >> P0606 - Control Module Processor

P0606 - Control Module Processor

WARNING: This page does not describe the selected car, but rather 28 other vehicles, including the 2014 Lincoln Navigator, 2014 Lincoln MKZ, 2014 Lincoln MKX, 2014 Lincoln MKT, and 2014 Lincoln MKS. However, it is still accessible from the selected car via links, so may be relevant.
P0606 - CONTROL MODULE PROCESSOR

Description:  This DTC sets when there is an internal PCM communication error.
Possible Causes: 
  • Module programming error
  • Aftermarket performance products
  • Damaged PCM
Diagnostic Aids:  Reprogram or update the calibration. Check for other DTCs and diagnose those first. Check for aftermarket performance products before installing a new PCM. Clear the DTCs, repeat the self-test. If the DTC is retrieved again, install a new PCM. Refer to FLASH ELECTRICALLY ERASABLE PROGRAMMABLE READ ONLY MEMORY (EEPROM) , Programming the VID Block for a Replacement PCM.
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
All Refer to the Description, Possible Causes and Diagnostic Aids for the DTC.
scientia non olet · About LEMON Manuals