LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 51 (Front Drive Axle/Differential -- F250-F550 Super Duty) >> In-Vehicle Repair >> Axle Shaft Seal >> Removal

Axle Shaft Seal: Removal

WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the wheel bearing and wheel hub assemblies. For additional information, refer to FRONT SUSPENSION - FOUR WHEEL DRIVE (4WD) .
  2. Using a suitable tool, drive the axle shaft knuckle seal out of the wheel knuckle.
    Fig 1: Removing Axle Shaft Knuckle Seal
    G06776394Courtesy of FORD MOTOR CO.
  3. Remove the axle shaft and knuckle seal.
    Fig 2: Removing Axle Shaft And Main Seal
    G07967042Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals